Specification  -  Drivers  -  Installation Guide

Installation Guide

Power on your computer to start Windows. It will detect your newly installed ADSL PCI Modem and prompt for its driver. Click Cancel.

Place the Installation CD into your CD-ROM Drive. A Main Menu will be prompted.

(If you do not see the Menu displayed, double-click on My Computer icon. Locate your CD-ROM Drive icon and double-click on it. Alternatively, you may double-click on the setup.exe at the util folder on the Installation CD.)

On the Menu, click the circle corresponding to the protocol you are installing. Installation will commence.

Depending on your system's configurations, you may be prompted for your Windows CD-ROM for some missing files. Replace the Installation CD in your CD-ROM drive with your Windows CDROM
and click OK.

If prompted for the files location, type in your Windows CD-ROM path in the text box and click OK. Allow some time for system to install and copy all required files for your modem.

Upon completion, system will automatically restart. (Rebooting may take a while.)

Once the drivers have been installed and you have rebooted, you will see a new icon near your clock. Right click on it and select configuration.

You should see the below screen. 

To configure VPI/VCI values, add multiple ISP names or multiple VPI/VCI values, click PVC Table, and you will see the below screen

To edit the existing configuration or to change the ISP Name, double-click on it. Overwrite the existing  values with your new ones and click OK.

To add a new configuration, click Add. Enter your new ISP Name, VPI, VCI values and click OK.

To remove an existing configuration, click on the ISP Name and click Remove.

You may activate any of your configurations by selecting the ISP Name and click Activate.

Left click on the text, and select "edit". Note: I let it use ANSI T1.413 mode.

You edit the text to this below, then go back to the PVC Table screen, and Activate.

When it's all done, you should see the small icons near the clock flash as the modem syncs with the exchange.

When you have 2 solid black icons, you are ready to connect 

Creating a connection for the DSLW700P PCI modem.

From your Windows desktop, a ADSL PCI Modem dial-up icon will be generated. Double-click on it.

Click on it, and you will see

Enter you username and password, and connect :)

Upon successful dial-up, you should be able to see an icon ( ) displayed at the corner of your Windows taskbar.

Double-click on the icon. You will be able to see the following information.

(The connection speed indicates the speed that the ADSL modem can achieved. Your actual connection speed will depend on the subscription plan that you have signedup with your ADSL Service Provider.)

Check your connection time by looking at the Duration. Click Disconnect to end the session.

Thanks to DSL-Warehouse for the above information.